Abstract
|
Article Information:
Design and Analysis of Single Screw Extruder for Jatropha Seeds Using Finite Element Method
Ali Nurrakhmad Siregar, Wan Mohd Faizal Wan Mahmod, Jaharah A. Ghani, Che Hassan Che Haron and Muhammad Rizal
Corresponding Author: Ali Nurrakhmad Siregar
Submitted: July 4, 2013
Accepted: July 16, 2013
Published: March 15, 2014 |
Abstract:
|
Mechanical extraction is commonly used to extract oils from vegetable seeds and a single screw extruder has been successfully reported to separate oil and cake from Jatropha curcas seeds. In this study, a single screw extruder was designed and analyzed using Finite Element Method (FEM) and Computational Fluid Dynamics (CFD). Three different geometrical dimensions of screw extruder were designed and analyzed using FEM and CFD with software ANSYS POLYFLOW to study simulation of the flow and the behavior of Jatropha dough through of a single screw extruder. In a preliminary study, this study focused to simulate the velocity profile and local shear rate indie section with a power law model. The result obtained revealed that three important are as in designing a single screw extruder were gap area (clearance) in the range of 0.5-1.0 mm, chamber area (normal pitch) in the range 17-22 mm and root area.
Key words: Computational fluid dynamic, finite element method, Jatropha, single screw extruder , , ,
|
Abstract
|
PDF
|
HTML |
|
Cite this Reference:
Ali Nurrakhmad Siregar, Wan Mohd Faizal Wan Mahmod, Jaharah A. Ghani, Che Hassan Che Haron and Muhammad Rizal, . Design and Analysis of Single Screw Extruder for Jatropha Seeds Using Finite Element Method. Research Journal of Applied Sciences, Engineering and Technology, (10): 2098-2105.
|
|
|
|
|
ISSN (Online): 2040-7467
ISSN (Print): 2040-7459 |
|
Information |
|
|
|
Sales & Services |
|
|
|